FEATURES OF ONE-PART ADDITION MID-TEMPERATURE CURED SILICONE RUBBER GOLOHO-4337

·One-part addition mid-temperature cured conductive silicone adhesive sealant
·Easy to use . no need to mix ,vacuum and exhaust bubble.
·Semi-flowable .
·Cures with heat to an elastomer in a short period of time .no by-product.
·Excellent adhesion sealant to Various metals ,glass, ceramics and plastics. No primer needed.
·After cured ,elastomer stable from -50°C – 250°C .
·Excellent insulation and flammable retardant .
·Excellent weatherability and temperature resistance. Non-corrosive to chemical product.
·Tolerance to UV, ozone and chemical products when outdoor use,
·Superior deep section cure .
·Superior high temperature performance. low coefficient of linear expansion
Description
GOLOHO-4337 is a one-part, low viscosity allows for excellent flowability and non-corrosive to metal , heat curable silicone rubber designed for electric and electronic parts required high speed cured and strong tensile strength (without primer ) sealant and adhesion. This product cures with heat to form rubber.
TYPICAL PRODUCT DATA OF ONE-PART ADDITION MID-TEMPERATURE CURED SILICONE RUBBER GOLOHO-4337
Typical uncured propertie 4337R 4337RM 4337RH 4337G 4323 4321
Appearance semi-flowable
Color Red Grey Black White
Adhesion rate  pas(P) 12.5(125) 17(170) 25(250) 12.5(125) 16(160) 18(180)
TYPICAL mechanical PROPERTIES
Specific gravity   g/ cm3 1.45 1.46 1.48 1.45 1.45 1.46
Hardness Type A(A) 38 38 40 38 38 39
Tensile strength  MPa (kgf/ cm2) 2.9 2.9 3.0 2.9 3.0 3.0
Adhesive strengthMPa(kgf/ cm2) 1.8 1.8 1.5 1.8 1.5 1.5
Elongation  % 170 160 150 170 150 150
TYPICAL electrical PROPERTIES (CURED)
Strength of breakdown voltage  kV/mm 20 20 20 20 20 20
Dielectric constant  1Mhz 3.4×1014 3.4×1014 3.4×1014

CURE PROPERTY OF ONE-PART ADDITION MID-TEMPERATURE CURED SILICONE RUBBER GOLOHO-4337
Typical cure time and temperature
Temperature Cure time
150 12
200 8

A cure time required is subjected to heat condition, specific application form and efficiency.
generally, a sample test should be taken to confirm it.
TYPICAL IRON CURE TIME AND WAY OF ONE-PART ADDITION MID-TEMPERATURE CURED SILICONE RUBBER GOLOHO-4337
Typical iron cure time and way (by electricity heating)
Power(W) Once time(s) Second time(s)
1400 60+